The chemical properties of oxygen are vivid. In addition to rare gases and small active metal elements such as gold, platinum and silver, most of the elements can react with oxygen, which is combustion-supporting and oxidizing. Owing to the chemical nature of oxygen, oxygen pressurization equipment must be designed safely, explosion-proof and oil-free.
The development of Fiente brand oxygen booster filling equipment can well deal with the problems encountered in the filling or pressurizing process of oxygen. The use of two secondary pumps to stop parallel operation, plus the special disposal of the central component oxygen booster pump, can complete: efficient, energy-saving, safe and integrated filling method, better meet customer filling and pressurization needs.
Principle of Oxygen Supercharging Equipment
Fiente ZTT oxygen booster pump series is a two-stage booster pump, which can increase oxygen at very low pressure to very high pressure. When the driving gas is less than 8 bar, the pressure range of the oxygen inlet is 0.5-10 bar, which can be increased to 30 Mpa. The whole oxygen booster pump is made of aluminium alloy and stainless steel. The driving piston diameter of this series of pumps is 160 mm, and the pump heads at both ends are equipped with exhaust cooling. It can make the temperature of oxygen booster pump not too high in working hours. And the driving air can be effectively applied after it is released.
Parameters of Oxygen Filling System
Driving Pressure: 3-8bar
Inlet pressure range: 0.5-10 bar
Output pressure range: 0-30 Mpa
Output flow: 380L/min
Drive port G1/2, oxygen inlet ZG1/2, high-pressure outlet ZG1/4 (can be made according to customer request non-calibration)
I believe that after reading the introduction of the gas booster pump in this paper, I will have my own understanding of this aspect, and other problems can be solved well in the future.